Job-Site Equipment Corp.

Information

2022 Caterpillar Generator Set Control Panels EMCP 4.3 Control Panel

The EMCP 4 Control Panel provides all of the controls and system indicators in one easy to access interface.

Features may include:

• The EMCP 4 includes the following controls:

• Auto / Start / Stop Control

• Speed and Voltage Adjust

• Engine Cycle Crank

• Programmable Cycle Timer

• 24-volt DC operation

• Environmental sealed front face

• Text alarm/event descriptions

• Remote start / stop

• Engine Cooldown Timer

• Local and remote emergency stop

• RPM

• DC volts

• Operating hours

• Oil pressure (psi, kPa or bar)

• Coolant temperature

• Volts (L-L & L-N), frequency (Hz)

• Amps (per phase & average)

• ekW, kVA, kVAR, kW-hr, %kW, PF

• Battery voltage

• Oil Temperature

• Multiple Language Support

• Crank attempt and successful start counter

• Run hours

• Enhanced engine monitoring (with electronic engines)

• The EMCP 4 has common LED indicators of the following warning and shutdown conditions

• Low oil pressure

• High coolant temperature

• Overspeed

• Emergency stop

• Failure to start (overcrank)

• Low coolant temperature

• Low coolant level

• Low engine oil pressure (alarm)

• High engine oil temp (alarm and shutdown)

• High coolant temp (alarm and shutdown)

• Low coolant temp (alarm)

• Low coolant level (alarm)

• Control switch not in auto (alarm)

• Low, high, and weak battery voltage

• Generator phase sequence

• Over/Under voltage (27/59)

• Over/Under Frequency (81 o/u)

• Reverse power (kW) (32)

• Reverse reactive power (kVAr) (32RV)

• Overcurrent (50/51)

• Reverse Power (kW)(32)

• Six digital inputs

• Emergency stop pushbutton

• Six relay outputs (Form A)

• Two relay outputs (Form C)

• Two digital outputs

• One Analog Input

• customer data link (Modbus RTU)

• Accessory module data link

• Serial annunciator module data link

• The EMCP 4 is compatible with:

• Remote CAN annunciator

• Remote serial annunciator

• Local Annunciator

• Remote Monitoring Software

• Digital I/O module

• RTD module

• Thermocouple module

• A 33 x 132 pixel, 3.8 inch, graphical display denotes text alarm/event descriptions, set points, engine and generator monitoring and is visible in all lighting conditions

• Voltage (L-L, L-N)

• Current (Phase)

• Average Volt, Amp, Frequency

• kW, kVAr, kVA (Average, Phase, %)

• Power Factor (Average, Phase)

• kW-hr, kVAr-hr (total)